Please watch the quick video below, installation just takes a few minutes for each side.
Bellow follows an AI-generated step-by-step instructions.
- Preparation:
- Park your Cybertruck in a clean, shaded area to prevent the solution from drying too quickly during application.
- Thoroughly clean the rocker panels to remove any dirt, dust, or debris. Use a microfiber cloth to ensure the surface is dry and free from contaminants.
- Create the Application Solution:
- Fill a spray bottle with water and add a few drops of mild dish soap. This solution will allow you to reposition the film during installation.
- Position the Film:
- Carefully remove the backing from the Xpel Armor film, exposing the adhesive side.
- Generously spray the adhesive side of the film with the soap and water solution.
- Align the film with the edges of the rocker panel, ensuring it covers the desired area. The solution will allow you to slide and adjust the film for precise placement.
- Apply the Film:
- Once positioned correctly, use a squeegee or soft-edged tool to gently press the film onto the rocker panel surface.
- Start from the center and work your way outward, pushing out any air bubbles and excess solution.
- Be patient and methodical to ensure a smooth, bubble-free application.
- Finalize the Installation:
- If necessary, use a heat gun or hairdryer on a low setting to gently warm the film, especially around curves or edges. This will help the film conform to the surface and enhance adhesion.
- Allow the film to cure and adhere properly by avoiding washing the vehicle or exposing it to harsh conditions for at least 24 hours.
