These are very easy to install, but please remember to clean the area first. Here's a quick video:
Installing the logo inserts
- Clean the debossed logo on the aero cover or center cap with the supplied alcohol pad. Run your fingernail around the inside edges so the pad reaches into the corners of the debossed area.
- Take the first (lower) piece. Peel off the clear protective film from the face if it is still attached.
- Peel the backing off the adhesive on the rear. Handle the piece by its edges and avoid touching the adhesive.
- Line the piece up using the inverted V at the top of the debossed area and let it settle into the recess.
- When you are happy with the position, press lightly to set it. Only a little pressure is needed.
- Take the second (top) piece. Remove the protective film from the face if it is still attached, then peel the backing off the adhesive.
- Slide this piece in from the side and tuck it into the recess so it sits flush, then press it down.
- Repeat on the remaining three wheels.
The inserts fit the 19" Cross Flow aero covers and the 20" Helix center caps, which use the same debossed logo.
